Arctic Cat 300 Utility Service Manual page 56

7. Remove the shift fork; then remove the main shaft
assembly.
8. Remove the countershaft; then remove the primary
drive axle.
A. Transmission (Utility)
1. Drain the transmission lubricant into a suitable con-
tainer; then install the drain plug and tighten to 21 ft-
lb.
KM621

NOTE: If the engine has not been removed, remove
the swing arm assembly (see Suspension - Swing
Arm).
2. Using a crisscross pattern, remove four cap screws
securing the secondary driven bevel gear assembly to
the transmission case cover; then remove the assem-
bly. Account for an O-ring.
KM622A
3. Remove the three cap screws securing the secondary
drive bevel gear cover; then remove the cover.
Account for a gasket.
KM627B
4. Remove the speedometer gear retainer nut, washer,
and speedometer gear.
KM106
KM646A
KM648A
53