Right-Side Components; Removing Right-Side Components - Arctic Cat Altera 300 Service Manual

KM368
7. Install the alignment pins and a new gasket on the
crankcase; then install the V-belt cover and secure
with the cap screws. Tighten securely.
8. Install the recoil starter and secure with the cap
screws. Tighten securely.

Right-Side Components

 AT THIS POINT
To service center crankcase components only, proceed
to Removing Right-Side Components.
 NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to be
addressed and to service only those components. The
technician should use discretion and sound judgment.
AT THIS POINT

To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
 NOTE: The engine/transmission does not have to be
removed from the frame for this procedure.
Removing Right-Side
Components
A. Transmission
1. Drain the transmission lubricant into a suitable con-
tainer; then install the drain plug (A) and tighten to
21 ft-lb.
KM954B
 NOTE: If the engine has not been removed, remove
the swing arm assembly (see Drive System - Rear
Drive Axle - REMOVING).
2. Using a crisscross pattern, remove four cap screws
securing the secondary driven bevel gear assembly to
the transmission case cover; then remove the assem-
bly. Account for an O-ring.
KM646A
3. Remove the three cap screws securing the secondary
drive bevel gear cover; then remove the cover.
Account for a gasket.
KM648A
4. Remove the speedometer gear retainer nut, washer,
and speedometer gear.
49