Arctic Cat 300 Utility Service Manual page 36

4. Remove the gas tank cover panel and gas tank vent
hose.
5. Remove the side panels; then remove the front rack
and front fenders (see Steering/Frame/Controls).
6. Remove the air filter housing (see Fuel/Lubrication/
Cooling.
7. Remove the gas tank (see Fuel/Lubrication/Cooling).
8. Remove the muffler assembly (see Steering/Frame/
Controls).
9. Remove the carburetor (see Fuel/Lubrication/Cool-
ing).
10. Remove the coil (see Electrical System).
11. Disconnect the stator connector, shift position con-
nector, trigger coil connector, and coolant tempera-
ture sensor.
KM314A
KM314B
12. Remove the starter positive wire; then remove the
engine ground wire from the crankcase.
KM106A
13. Remove the front and rear V-belt cooling boots from
the V-belt housing; then remove the coolant hoses
from the engine.
KM347A
KM324A
KM319A
KM359A
33