Arctic Cat 300 Utility Service Manual page 58

10. Remove the countershaft and driveshaft as an assembly.
11. To disassemble the countershaft, use the following
procedure.
A. Remove the thrust washer and high gear clutch
dog.
B. Remove the high drive gear circlip and washer;
then remove the high drive gear and thrust
washer.
KM680
12. To disassemble the driveshaft, use the following pro-
cedure.
A. Remove the thrust washer; then remove the
reverse gear.
KM681
B. Remove a thrust washer and the low/reverse
clutch dog.
KM684
C. Remove the low driven gear snap ring and
washer; then remove the low driven gear and
thrust washer.
KM685
KM689A
KM690A
55