Arctic Cat 300 Utility Service Manual page 24

6. Turn the handlebar to the left; then raise the body
turning it to the right and lift clear of the handlebar.
REMOVING (Utility)
1. Remove the seat; then remove the battery box cover.
2. Disconnect the negative battery cable first; then the
positive cable.
3. Remove the battery hold-down strap; then remove
the battery.
4. Remove the front and rear racks; then remove the
cap screws securing the front center panel and
remove the panel.
5. Remove the cap screws and flange nuts securing the
mud guards to the front and rear fenders; then
remove the cap screws securing the mud guards to
the front rests and remove the mud guards.
KM352A
6. Remove the side panels; then remove the cap screws
and flange nuts securing the front and rear fenders to
the frame and fender supports.
7. Disconnect the left and right headlight connectors;
then disconnect the taillight.
KM793A
8. Remove the gas tank cover; then remove the shift
knob and front and rear fenders.
CLEANING AND INSPECTING
1. Clean all body components with soap and water.
2. Inspect the body and fenders for cracks.
KM308A
3. Inspect threaded areas of all mounting studs for strip-
ping.
4. Inspect for missing decals.
INSTALLING (DVX)
1. Fit the body over the handlebar and rotate into nor-
mal mounting position.
KM789A
KM799B
KM797
21