Vacuum Reservoir Installation; Speed Control System Specifications; Vacuum Reservoir Location - Jeep 200 Cherokee Service Manual

XJ
REMOVAL AND INSTALLATION (Continued)
(3) Remove 2 reservoir mounting screws.
(4) Remove reservoir from bumper bar.
Fig. 5 Vacuum Reservoir Location
1 – BUMPER END CAP
2 – VACUUM RESERVOIR
INSTALLATION
(1) Position reservoir to bumper bar and install
mounting screws. Tighten screws to 8 N·m (72 in.
lbs.) torque.
(2) Install vacuum line to reservoir
(3) Install front bumper end cap. Refer to Front
Bumper End Cap Removal/Installation.
SPEED CONTROL SYSTEM
Fig. 6 Vacuum Reservoir Removal/Installation
1 – VACUUM LINE
2 – RESERVOIR SCREWS
3 – VACUUM RESERVOIR
SPECIFICATIONS
TORQUE CHART
Description
Servo Mounting Bracket-to-Servo Nuts . . . 8.5 N·m
Servo Mounting Bracket-to-Body Bolts . . . . . 2 N·m
Speed Control Switch Mounting Screws . . . 1.5 N·m
Vacuum Reservoir Mounting Bolts . . . . . . . . 8 N·m
8H - 7
Torque
(75 in. lbs.)
(20 in. lbs.)
(14 in. lbs.)
(72 in. lbs.)