License Plate Lamp Bulb Removal And Installation; Chmsl Bulb Removal And Installation; Underhood Lamp Bulb Removal And Installation; Underhood Lamp Lens - Jeep 200 Cherokee Service Manual

8L - 12 LAMPS
REMOVAL AND INSTALLATION (Continued)
LICENSE PLATE LAMP BULB
REMOVAL
(1) Remove screws attaching license plate lamp
housing to liftgate.
(2) Rotate bulb socket
remove bulb socket from lamp housing.
(3) Pull bulb from socket.
INSTALLATION
(1) Install bulb in lamp socket.
(2) Install bulb socket in lamp housing.
(3) Install screws attaching license plate lamp
housing to liftgate.
CENTER HIGH MOUNTED STOP LAMP
(CHMSL) BULB
REMOVAL
(1) Remove the screws attaching the lamp housing
to the liftgate.
(2) Rotate bulb socket 1/4 turn counter-clockwise
and pull from housing (Fig. 6).
(3) Pull bulb from socket.
Fig. 6 CHMSL Bulb
1 – CHMSL BULB
2 – BULB SOCKET
3 – CHMSL LAMP HOUSING
INSTALLATION
(1) Push bulb into socket.
(2) Position socket in lamp and rotate 1/4 turn
clockwise.
(3) Install screws attaching lamp housing to the
liftgate.
counter-clockwise and
UNDERHOOD LAMP BULB
REMOVAL
(1) Insert a small flat blade in the access slot
between the lamp base and lamp lens.
(2) Pry the lamp lens upward and remove the
lamp lens (Fig. 7).
(3) Depress the bulb terminal inward (Fig. 8) to
release the bulb.
Fig. 7 Underhood Lamp Lens
1 – LAMP
2 – LAMP LENS
Fig. 8 Underhood Lamp Bulb
1 – BULB
2 – DEPRESS TERMINAL INWARD
3 – BULB WIRE LOOP
4 – LAMP BASE
INSTALLATION
(1) Engage the replacement bulb wire loop to the
terminal closest to the lamp base wire connector.
XJ