Power Steering Pump Attachment-4.0L - Jeep 200 Cherokee Service Manual

XJ
REMOVAL AND INSTALLATION (Continued)
1 – PUMP ASSEMBLY
2 – PUMP BRACKET
pump. Also, the gasket is installed dry. Tighten
mounting bolts to 23 N·m (17 ft. lbs.) torque. Rotate
the shaft by hand to be sure it turns freely.
(4) Connect the radiator and heater hoses to the
water pump.
(5) Position water pump pulley to water pump
hub.
(6) Install four pump pulley bolts. Tighten bolts (or
nuts) to 27 N·m (20 ft. lbs.) torque.
(7) Install power steering pump. Refer to Group
19, Steering for proper procedure and torque values.
(8) Install the viscous fan and shroud together.
Install the four fan to idler pulley nuts and tighten
to 27 N·m (20 ft. lbs.).
CAUTION: When installing the accessory drive belt,
the belt MUST be routed correctly. If not, the engine
may overheat due to the water pump rotating in the
wrong direction. Refer to the Belt Removal and
Installation in this group for appropriate belt rout-
ing. You may also refer to the Belt Routing Label in
the vehicle engine compartment.
(9) Install and tighten viscous fan shroud bolts to
4 N·m (31 in. lbs.).
(10) Install and tension the accessory drive belt,
refer to Accessory Drive Belt removal and installa-
tion in this group.
(11) Install the electric cooling fan/shroud assy.
(12) Install and tighten electric fan shroud bolts to
4 N·m (31 in. lbs.). Connect fan connector.
Fig. 30 Power Steering Pump Attachment-4.0L
Fig. 31 Water Pump Remove/Install—Typical
1 – HEATER HOSE FITTING
2 – UPPER VENT HOLE
3 – PUMP GASKET
4 – WATER PUMP
5 – LOWER VENT HOLE
6 – LONG BOLT
7 – BOLTS (3) SHORT
COOLING SYSTEM 7 - 27