Starting Systems Specifications - Jeep 200 Cherokee Service Manual

XJ
CLEANING AND INSPECTION (Continued)
service manual for the location of the proper starter
motor removal and installation procedures.
• Starter Solenoid Visually inspect the starter
solenoid for indications of physical damage and loose
or corroded wire harness connections. Clean corroded
connections as required. Refer to Wiring Diagrams
in the index of this service manual for the location of
the proper wiring repair or connector and terminal
service procedures. Refer to Starter Motor in the
index of this service manual for the location of the
proper starter solenoid service procedures.
SPECIFICATIONS
STARTING SYSTEM
Manufacturer
Engine Application
Power Rating
Voltage
Number of Fields
Number of Poles
Number of Brushes
Drive Type
Free Running Test Voltage
Free Running Test Maximum Amperage Draw
Free Running Test Minimum Speed
Solenoid Closing Maximum Voltage Required
*Cranking Amperage Draw Test
*Test at operating temperature. Cold engine, tight (new) engine, or heavy oil will increase starter amperage draw.
• Wiring Visually inspect the starting system wire
harnesses for indications of physical damage. Repair
or replace any faulty wiring, as required. Refer to
Starting System in the index of this service manual
for the location of complete starting system wiring
diagrams. Refer to Wiring Diagrams in the index of
this service manual for the location of the proper wir-
ing repair or connector and terminal service proce-
dures.
Starter Motor and Solenoid
STARTING SYSTEMS
Mitsubishi
2.5L, 4.0L
2.5L - 1.2 Kilowatt (1.6 Horsepower)
4.0L - 1.4 Kilowatt (1.9 Horsepower)
12 Volts
4
4
4
Planetary Gear Reduction
11.2 Volts
90 Amperes
2.5L - 2600 rpm
4.0L - 2500 rpm
7.8 Volts
2.5L - 130 Amperes
4.0L - 160 Amperes
8B - 15