Double Cardan Joint Assembly; Remove Bearing From Yoke; Remove Centering Kit; Install Bearing Cap - Jeep 200 Cherokee Service Manual

3 - 12 PROPELLER SHAFTS
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 25 Remove Bearing From Yoke
Fig. 26 Remove Centering Kit
ASSEMBLY
During assembly, ensure that the alignment
marks on the link yoke and propeller shaft
yoke are aligned.
(1) Apply extreme pressure (EP) N.L.G.I. Grade 1
or 2 grease to inside of yoke bores to aid in installa-
tion.
(2) Fit a cross into the propeller shaft yoke (Fig. 27).
Fig. 27 Install Cross In Yoke
(3) Place a bearing cap over the trunnion and
align the cap with the yoke bore (Fig. 28). Keep the
needle bearings upright in the bearing assembly. A
needle bearing lying at the bottom of the cap will
prevent proper assembly.
Fig. 28 Install Bearing Cap
(4) Press the bearing cap into the yoke bore
enough to install a snap ring (Fig. 29).
(5) Install a snap ring.
XJ