Reading And Courtesy Lamp Bulb Removal And Installation; Garage Door Opener Storage Bin Door Removal And Installation; Sunglasses Storage Bin Removal And Installation; Ambient Temperature Sensor Removal And Installation - Jeep 200 Cherokee Service Manual

8V - 8 OVERHEAD CONSOLE SYSTEMS
REMOVAL AND INSTALLATION (Continued)
Fig. 5 Push Button Module Remove/Install
1 – PUSH BUTTON MODULE
2 – MOUNTING SCREWS
READING AND COURTESY LAMP BULB
(1) Disconnect and isolate the battery negative
cable.
(2) Insert a long, narrow, flat-bladed tool in the
notch on the edge of the reading and courtesy lamp
lens.
(3) Gently pry the lens downward from the over-
head console housing and pivot the lens down. It may
be necessary to move the tool along the edge of the
lens to free the lens from the console housing.
(4) Unsnap the bulb from the bulb holders by pull-
ing the bulb gently downwards.
(5) Install a new bulb by aligning its base with the
bulb holders and pushing the bulb firmly into place.
(6) Pivot the lens back up into position and press
upward firmly until it snaps into place.
(7) Connect the battery negative cable.
(8) Test the lamp by depressing the lens to check
for proper lamp switching and lighting.
GARAGE DOOR OPENER STORAGE BIN DOOR
(1) Open the garage door opener storage bin door.
(2) Using a trim stick or another suitable wide
flat-bladed tool, gently pry between the door pivot
pin and the pivot hole on one side of the overhead
console housing until the pivot pin clears the pivot
hole.
(3) Use a gentle twisting action to remove the
garage door opener storage bin door from the over-
head console housing.
(4) To install, insert the pivot pin on one side of
the door into the pivot hole in the overhead console
housing. Gently depress the pivot pin on the other
side of the door until it clears the side of the garage
door opener storage bin opening of the overhead con-
sole housing, and push the door into the opening.
Guide the door into the opening so that the second
pivot pin snaps into its pivot hole.
SUNGLASSES STORAGE BIN
The sunglasses storage bin door and bin, housing,
damper, spring and latch are serviced only as a unit.
Remove the sunglasses storage bin module from the
overhead console as follows:
(1) Remove the overhead console from the vehicle.
See Overhead Console in this group for the proce-
dures.
(2) Disengage the overhead console courtesy lamp
wire harness from the retainers molded into the sun-
glasses storage bin housing.
(3) Remove the six screws that secure the sun-
glasses storage bin module to the overhead console
housing (Fig. 6).
Fig. 6 Sunglasses Storage Bin Module Remove/
1 – SUNGLASSES STORAGE BIN MODULE
2 – MOUNTING SCREWS
3 – WIRE HARNESS RETAINERS
(4) Remove the sunglasses storage bin module
from the overhead console.
(5) Reverse the removal procedures to install.
Tighten the mounting screws to 2.2 N·m (20 in. lbs.).
AMBIENT TEMPERATURE SENSOR
(1) Disconnect and isolate the battery negative
cable.
(2) Locate the ambient temperature sensor, below
the grille and behind the front bumper on the radia-
tor support crossmember (Fig. 7).
(3) Unplug the ambient temperature sensor wire
harness connector.
(4) Remove the screw that secures the ambient
temperature sensor to the radiator support cross-
member.
(5) Remove the ambient temperature sensor from
the vehicle.
Install
XJ