Front Position Lamp Bulb Removal And Installation; Side Repeater Lamp Bulb Removal; Headlight Bezel Retaining Screws; Headlamp Retaining Screws - Jeep 200 Cherokee Service Manual

8L - 6 LAMPS
REMOVAL AND INSTALLATION
FRONT POSITION LAMP BULB . . . . . . . . . . . . . . . 6
SIDE REPEATER LAMP BULB . . . . . . . . . . . . . . . . 6
REMOVAL AND INSTALLATION
FRONT POSITION LAMP BULB
REMOVAL
(1) Remove the 2 screws holding the headlamp
bezel in place and remove bezel (Fig. 1).
Fig. 1 Headlight Bezel Retaining Screws
(2) Remove the 4 screws holding the headlamp
(Fig. 2).
Fig. 2 Headlamp Retaining Screws
2000 JEEP CHEROKEE
LAMP BULB SERVICE
TABLE OF CONTENTS
page
REAR FOG LAMP BULB . . . . . . . . . . . . . . . . . . . . 7
LICENSE PLATE LAMP BULB . . . . . . . . . . . . . . . . 7
(3) Pull the front position lamp straight from
headlamp (Fig. 3).
1 – GROMMET
2 – SOCKET
(4) Remove the front position lamp bulb from
socket.
INSTALLATION
(1) Install the front position lamp bulb in lamp
socket.
(2) Verify lamp operation.
(3) Install front position lamp in headlamp.
(4) Connect headlamp electrical connector.
(5) Position the headlamp, headlamp retaining
ring and install the retaining screws.
(6) Position the headlamp bezel and install retain-
ing screws.
SIDE REPEATER LAMP BULB
REMOVAL
(1) Grip the side repeater lamp assembly and pull
straight from the fender.
(2) Rotate and pull the socket from the housing
(Fig. 4).
(3) Pull the bulb straight from the socket.
Fig. 3 Front Position Lamp Grommet & Socket
Location
XJ
page