Jeep 200 Cherokee Service Manual page 225

5 - 4 BRAKES
REMOVAL AND INSTALLATION (Continued)
(4) Install combination valve/bracket and retaining
nuts.
(5) Install brake lines on cylinder and valve.
Torque brake lines to 19 N·m (170 in. lbs.).
(6) Connect differential pressure switch wire on
the combination valve.
(7) Fill and bleed the brake system. Refer to the
procedure in this group.
(8) Connect the negative battery cable.
(9) Adjust the brake lamp switch. Refer to the pro-
cedure in this group.
WARNING: Be certain
achieved prior to attempting to operate the vehicle.
2000 JEEP CHEROKEE
a firm brake pedal
SPECIFICATIONS
TORQUE SPECIFICATIONS
DESCRIPTION
Brake Booster to Cowl Panel
Nuts . . . . . . . . . . . . . . . . . . . . . 39 N·m (29 ft. lbs.)
Brake Lines at Master Cylinder and
Combination Valve
Tube Nuts . . . . . . . . . . . . . . . . 19 N·m (170 in. lbs.)
Master Cylinder to Vacuum Booster
Nuts . . . . . . . . . . . . . . . . . . . 17.5 N·m (155 in. lbs.)
is
XJ
TORQUE