Check Valve; Rear Washer System Check Valve - Jeep 200 Cherokee Service Manual

XJ
REMOVAL AND INSTALLATION (Continued)
(2) Disconnect the washer supply hose from the
barbed rear washer nozzle nipple.
(3) Reverse the removal procedures to install.

CHECK VALVE

(1) Remove the four screws that secure the liftgate
opening upper garnish moulding to the upper liftgate
opening reinforcement.
(2) Using a trim stick or another suitable wide-
bladed flat tool, gently pry the liftgate opening upper
garnish moulding away from the upper liftgate open-
ing reinforcement to release the snap clip retainers.
(3) Remove the garnish moulding from the upper
liftgate opening.
(4) Disconnect the liftgate half of the washer sup-
ply hose from the barbed nipple of the rear washer
system check valve.
(5) Disconnect the body half of the washer supply
hose from the other barbed nipple of the rear washer
system check valve.
(6) Remove the check valve from the vehicle.
WIPER AND WASHER SYSTEMS
(7) When reinstalling the check valve, be certain
the valve is properly oriented within the system flow
(Fig. 20).
Fig. 20 Rear Washer System Check Valve
1 – TO RESERVOIR
2 – CHECKBALL
3 – SPRING
4 – TO NOZZLE
(8) Reverse the remaining removal procedures to
complete the installation.
8K - 15