Washer System Removal And Installation; Washer Reservoir; Washer Pump; Washer Reservoir Filler Neck Remove/Install - Jeep 200 Cherokee Service Manual

XJ
REMOVAL AND INSTALLATION (Continued)
wiper and washer switch receptacle on the back of
the accessory switch bezel and pull the switch out of
the bezel.
(8) Reverse the removal procedures to install. Be
certain that both of the switch snap clip retainers in
the receptacle on the back of the accessory switch
bezel are fully engaged. Tighten the mounting screws
to 2.2 N·m (20 in. lbs.).
WASHER SYSTEM

WASHER RESERVOIR

(1) Disconnect and isolate the battery negative
cable.
(2) The washer reservoir filler neck is held in the
reservoir by an interference fit. Remove the filler
neck from the reservoir using a combination of pull-
ing, rocking and twisting actions (Fig. 16).
Fig. 16 Washer Reservoir Filler Neck Remove/Install
1 – RESERVOIR
2 – LEFT FENDER
3 – FILLER NECK AND CAP
(3) Remove the engine air filter housing. Refer to
Group 14 - Fuel System for the procedures.
(4) Remove the two screws that secure the washer
reservoir to the inner fender shield (Fig. 17).
(5) Raise and support the vehicle.
(6) Remove the left front inner wheelhouse splash
shield. Refer to Group 23 - Body for the procedures.
(7) Remove the washer supply hose(s) from the
washer pump(s) and drain the washer fluid from the
reservoir into a clean container for reuse.
(8) Unplug the wire harness connectors from the
washer pump(s) and the washer fluid level sensor.
(9) Slide the reservoir slightly towards the rear of
the vehicle to release the two hooks from the inner
fender ledge slots.
(10) Lower the front of the washer reservoir and
slide the unit forward to remove it from the vehicle.
WIPER AND WASHER SYSTEMS
Fig. 17 Washer Reservoir Remove/Install
1 – SCREW
2 – FENDER
3 – WASHER RESERVOIR
4 – FILLER NECK
5 – SCREW
6 – FLUID LEVEL SENSOR
7 – REAR WASHER PUMP
8 – FRONT WASHER PUMP
9 – HOOK
(11) Reverse the removal procedures to install.
Tighten the reservoir mounting screws to 3 N·m (26
in. lbs.).

WASHER PUMP

(1) Disconnect and isolate the battery negative
cable.
(2) Raise and support the vehicle.
(3) Remove the left front inner wheelhouse splash
shield. Refer to Group 23 - Body for the procedures.
(4) Remove the washer supply hose(s) from the
barbed outlet nipple of the washer pump(s) and drain
the washer fluid from the reservoir into a clean con-
tainer for reuse.
(5) Unplug the wire harness connectors from the
washer pump(s).
(6) Using a trim stick or another suitable wide
flat-bladed tool, gently pry the barbed inlet nipple of
the washer pump out of the rubber grommet seal in
the reservoir. Care must be taken not to damage the
reservoir.
(7) Remove the rubber grommet seal from the res-
ervoir and discard.
8K - 13