Cluster Hood And Mask Removal; Cluster Housing Rear Cover Removal; Cluster Bulb Installation - Jeep 200 Cherokee Service Manual

8E - 20 INSTRUMENT PANEL SYSTEMS
REMOVAL AND INSTALLATION (Continued)
1 – CLUSTER REAR COVER
2 – CLUSTER HOOD AND MASK
3 – CLUSTER LENS
(4) Remove the odometer reset knob boot by pull-
ing it out of the cluster lens.
CLUSTER HOOD AND MASK
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the instrument cluster from the instru-
ment panel. Refer to Instrument Cluster in the
Removal and Installation section of this group for the
procedures.
(3) Remove the cluster lens from the cluster hous-
ing. Refer to Instrument Cluster Components -
Cluster Lens in the Removal and Installation sec-
tion of this group for the procedures.
(4) Work around the perimeter of the cluster hous-
ing to disengage each of the latches that secure the
cluster hood and mask unit to the cluster housing
(Fig. 14).
(5) Gently pull the cluster hood and mask unit
away from the cluster housing.
CLUSTER HOUSING REAR COVER
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the instrument cluster from the instru-
ment panel. Refer to Instrument Cluster in the
Fig. 14 Instrument Cluster Components
Removal and Installation section of this group for the
procedures.
ing to disengage each of the latches that secure the
rear cover to the cluster housing (Fig. 14).
of the cluster housing.
INSTALLATION
CLUSTER BULB
cluster illumination lamp or indicator lamp bulb and
bulb holder units. However, the illumination lamps
and the indicator lamps use different bulb and bulb
holder unit sizes. They must never be interchanged.
Be certain that any bulb and bulb holder unit
removed from the cluster electronic circuit board is
reinstalled in the correct position.
CAUTION: Always use the correct bulb size and
type for replacement. An incorrect bulb size or type
may overheat and cause damage to the instrument
cluster, the electronic circuit board and/or the
gauges.
4 – ODOMETER RESET KNOB BOOT
5 – INSTRUMENT CLUSTER HOUSING
(3) Work around the perimeter of the cluster hous-
(4) Gently pull the rear cover away from the back
This procedure applies to each of the incandescent
XJ