Radio Noise Suppression Components; Engine-To-Body Ground Strap Removal; Antenna Mast Remove/Install - Typical; Antenna Cap Nut And Adapter Remove/Install - Typical - Jeep 200 Cherokee Service Manual

XJ
REMOVAL AND INSTALLATION (Continued)
(4) Unscrew the antenna mast from the antenna
body (Fig. 13).
Fig. 13 Antenna Mast Remove/Install - Typical
1 – ANTENNA MAST
2 – ADAPTER
3 – CAP NUT
(5) Remove the antenna cap nut and adapter using
an antenna nut wrench (Special Tool C-4816) (Fig.
14).
Fig. 14 Antenna Cap Nut and Adapter Remove/
Install - Typical
1 – CAP NUT
2 – ANTENNA ADAPTER
3 – TOOL
(6) Lower the antenna body and cable assembly
through the top of the fender far enough to access
the antenna body by reaching up into the rear of the
right front fender wheel housing (Fig. 15).
(7) Disengage the coaxial cable grommet from the
hole in the right cowl side outer panel.
(8) Pull the coaxial cable out through the right
cowl side outer panel.
Fig. 15 Antenna Mounting
1 – NUT
2 – MAST
3 – RIGHT FRONT FENDER
4 – ANTENNA BODY AND CABLE
5 – GROMMET
6 – ADAPTER
(9) Remove the antenna body and cable from the
vehicle.
(10) Reverse the removal procedures to install.
Tighten the antenna cap nut to 6.2 N·m (55 in. lbs.).
Tighten the antenna mast to 3.3 N·m (30 in. lbs.).

RADIO NOISE SUPPRESSION COMPONENTS

WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
REMOVAL
ENGINE-TO-BODY GROUND STRAP
(1) Remove the screw that secures the engine-to-
body ground strap eyelet to the dash panel (Fig. 16).
AUDIO SYSTEMS 8F - 11
GROUP 8M - PASSIVE
STEERING COLUMN, OR