Table of Contents
Advertisement
6-2-5 Connect Off Time
6-2-5 Connect Off Time
6-2-5 Connect Off Time
Under the Bluetooth mode, when the Bluetooth connection is established while
the scanner is not working. This configuration enables to set the duration of
scanner sleep time. (Note: Default value is 6 as 60 seconds)
Configuration Range
0 ~ 42 Min 30secs
Procedure
(A) Scan "Enter" barcode
(B) Scan "Connect Off Time" barcode
(C) Scan parameters from
Hexadecimal / Decimal table
(D) Scan "OK" barcode
(E) Scan "End" barcode
6-2-6 Lamp Off Delay
6-2-6 Lamp Off Delay
6-2-6 Lamp Off Delay
The configuration enables the setting of duration time of scanner LED power
on and off .
Configuration Range
0 ~ 4 minutes 15 sec
Procedure:
(A) Scan "Enter" barcode
(B) Scan "LampOff Delay" barcode
(C) Scan parameters from
Hexadecimal / Decimal table
(D) Scan "OK" barcode
(E) Scan "End" barcode
ENTER
*/$%ENT*
6. Memory / Bluetooth General Setting
*6042*
Unit
Default Setting
10 secs
6 (as 1 minute)
Example
If configuration is 2 minutes, the
parameter value is 2 min / 10 sec =
12 ( 2minx 60 / 10sec = 12)
*6052*
Unit
1 sec
Example:
If configuration is 10 sec, the
parameter value is 10 sec / 1 sec =
10
73
Default Setting
5 sec
End
*ZEND*
Advertisement
Table of Contents
