Table of Contents
Advertisement
4-2-6 Bluetooth parameter configuration by software
4-2-6 Bluetooth parameter configuration by software
Procedures:
Connect scanner with PC by USB cable, and set the scanner to ISP
mode.
Scan the below barcodes step by step to set the scanner to ISP mode.
Note: ISP mode means scanner configuration mode.
Before any configuration with the software, scanner must scan above
two barcodes in order to perform software configuration.
When the scanner is in ISP mode, the PC might request for driver
installation, the driver is located in the CD (CM500\driver\ C0801.inf).
Execute "Bluetooth Setting" software, file located in the CD (CM500\ Software
\ Bluetooth setting\Bluetooth Setting.exe)
Go to device manager in windows system to make sure which com port
your scanner connected with (control panel
Hardware devices
*/$%ENT*
1.
ENTER:
*Z232*
2.
ISP:
COM port). for example: COM5)
36
4. Memory / Bluetooth Mode
system
hardware
Advertisement
Table of Contents
