Table of Contents
Advertisement
Scanner Operation Guide
Operation Mode
When plug in the USB cable
with scanner.
a)
It will start with short melody and the red
LED will be indicated.
b)
Execute Word, Excel or any word
processing software; scan the barcode will
transmit the barcode data to the word
processing software in real time.
c)
When the barcode is successfully read,
beep sound and green LED will be
indicated.
d)
Press the Erase key for few seconds until
beep sound indicates, any saved barcode
data will be upload to PC at once.
Note: after uploading the
barcode data to PC, the barcode
data in the memory will not be
erase. User needs to erase the
barcode data manually.
When Unplug the USB cable
with scanner.
a) It will automatically switch to Memory
mode / Bluetooth mode.
b) Press the erase key and point to the
scanned barcode label, this action will
erase the previously saved barcode
data in the memory scanner.
c) Press and hold the erase key for
approximately 8 seconds until the red
LED and beep indication, all barcode
data saved in the memory will be
erased.
2. Introduction
Transmitting barcode data
*/$%MTX*
(Send)
Send barcode data by Bluetooth OR
connected by USB cable.
Clear all saved barcode data
*/$%MCR*
(Clear)
Clear all barcode data in the memory
Warning: Scan the "Clear" barcode will
lose all the barcode data.
Mode Switching
*/$%TOM*
Switch from Bluetooth to Memory Mode
*/$%TOB*
Switch from Memory to Bluetooth Mode
I
mportant Note: For better Bluetooth
transmission quality, when holding the
scanner, please avoid covering the
reverse top cover.
20
Advertisement
Table of Contents
