Table of Contents
Advertisement
7- 10 Setup Timeout
7-10 Setup Timeout
This configuration enables to set the duration of scanner configuration time. If
user does not perform any actions after scanning the "Enter" barcode
(Configuration barcode) the setting mode will automatically exit.
Procedure:
(A) Scan "Enter" barcode
(B) Scan "Setup Timeout" barcode
(C) Scan Scan parameters from
Hexadecimal / Decimal table
(D) Scan "OK" barcode
(E) Scan "End" barcode
7-11 Vibrator Off Delay
7- 11 Vibrator OFF Delay
7- 11 Vibrator OFF Delay
This configuration enables to set the duration of vibrating time when the
barcode is successfully read and decoded. (Note: this configuration is only
applicable with optional purchased vibrator installed, and Good read
Vibrator function set as "Enable" Chapter: 7-3-3)
Procedure:
(A) Scan "Enter" barcode
(B) Scan "Vibrator Off Delay" barcode
(C) Scan Scan parameters from
Hexadecimal / Decimal table
(D) Scan "OK" barcode
(E) Scan "End" barcode
ENTER
*/$%ENT*
Configuration Range
0 ~ 4 minutes 15 sec
Configuration Range
0-2.5 Secs
7. General Configuration Setting
*0072*
Unit
Default Setting
1 sec
30 sec
Example:
If configuration is 10 sec, the
parameter value is 10 sec / 1sec =
10
*81A2*
Unit
Default Setting
0.01 sec
Example:
If configuration is 0.2 sec, the
parameter value is 0.2 sec / 0.01sec
= 20
110
0.1 sec
End
*ZEND*
Advertisement
Table of Contents
