Table of Contents
Advertisement
7- 5 Buzzer
7- 5 Buzzer
7-5 Buzzer
This section explains the Buzzer configuration when the barcode is
successfully read and decoded (note: Good read beep configuration must be
enabled before buzzer setting, please refer to chapter :7-3-2), the
configuration includes Beep volume, Beep tone and Beep time.
7- 5- 1 Beep Volume
7- 5- 1 Beep Volume
7-5-1 Beep Volume
Beep volume configuration enables to configure the volume of the Beep sound
Procedure:
(A) Scan "Enter" barcode
(B) Scan "Beep Volume" barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan "OK" barcode
(E) Scan "End" barcode
ENTER
*/$%ENT*
*8142*
Configuration Range
1 ~ 10
105
7. General Configuration Setting
Default Setting
10
End
*ZEND*
Advertisement
Table of Contents
