Erase Barcode Data (Single Data/ All Data) - Flash BT-49 User Manual

OR
2) Connect the USB cable between scanner and PC, and scan the below
"Send" barcode.

4-1-3 Erase barcode data (single data/ all data)

4-1-3 Erase barcode data (Single data / ALL data)
Erase single data:
Press the erase key and point to the scanned barcode, this action will
erase the last previous saved barcode data
in the memory.
Erase all data:
Press and hold the erase key for approximately 8 seconds until the red light
indicator ON, and beep sound indicates. All barcode data saved in the
memory will be erased.
Caution: Scan the "Clear" Barcode will erase all the barcode
data saved in the memory; make sure you have back up all
the barcode data before performing this action.
*/$%MTX*
(Send)
OR
By scanning the send barcode as below:
*/$%MCR*
(Clear)
Clear all barcode data in the memory
26
4. Memory / Bluetooth Mode