Table of Contents
Advertisement
In the software, please go to Sync
synchronization.
Configure scanner Bluetooth parameters, including Name (user preferred
device name for the scanner), Mac Address from the third party Bluetooth
dongle or devices, Password (user preferred password), and make sure
Bluetooth connection Mode is set as corresponding selection code.
( please refer to Bluetooth mode selection code table section :4-2-4-1)
Please refer to 4-2-3 section for
Bluetooth mode selection code.
Save the configuration parameters, and download the settings to scanner
(File Save
Note: User can also transfer the saved configuration to the scanner. The
procedure as following:
For synchronization procedure, please refer to above steps and select
File Open (and selected your saved configuration file)
T-parm File.
Exit the software, and disconnect the connection between Bluetooth
Setting software and scanner.
Note: for more detail, please refer to Bluetooth Setting instruction guide.
(CM500\manual\Bluetooth setting instruction guide.pdf)
Communication
37
4. Memory / Bluetooth Mode
COM PORT for
properties
User can configured preferred
Bluetooth scanner name
User needs to configure the Mac
address, Mac Address can be
find from Bluetooth hardware
devices properties, for example:
(0011b109da77)
User can configure preferred
password for Bluetooth
connection.
Download T-parm File)
Download
Advertisement
Table of Contents
