Lamp Off Delay - Flash BT-49 User Manual

Procedure:
(A) Scan "Enter" barcode
(B) Scan "LED Off Delay" barcode
(C) Scan parameters from
Hexadecimal / Decimal table
(D) Scan "OK" barcode
(E) Scan "End" barcode
Note: this configuration is only applicable when the scanner is in USB
cable mode.

7-8 Lamp Off Delay

7- 8 LAMP OFF Delay
This enables to configure the duration time for scanning LED power off, the
scanning LED will automatically turn off if duration time elapsed. This setting is
only available when the trigger mode is set as" Good read off" or "Timeout
Off"
Procedure:
(A) Scan "Enter" barcode
(B) Scan "LampOff Delay" barcode
(C) Scan Scan parameters from
Hexadecimal / Decimal table
(D) Scan "OK" barcode
(E) Scan "End" barcode
Note: this configuration is only applicable when the scanner is in USB
cable mode.
ENTER
*/$%ENT*
*8172*
Configuration Range
0 ~ 4 minutes 15 Sec
7. General Configuration Setting
Example:
If configuration is 0.1sec, the
parameter value is 0.1 sec / 0.01 sec
= 10
Unit Default Setting
1 sec 5 sec
Example:
If configuration is 10 sec, the
parameter value is 10 sec / 1 sec =
10
108
End
*ZEND*