Trouble Shooting - Rotax 914 series Maintenance Manual

Tool
Safety wiring
Cleaning of
parts
Before re-using disassembled parts, clean, check and refit them as per
Removed parts
instructions.
Use clean screws and nuts only and inspect face of nuts and thread for
damage. Check the contact faces and threads for damages. In case of
doubt, use new screws and nuts.
Once loosened, always replace self-securing nuts.
Nuts
At reassembly of the engine, replace all sealing rings, gaskets, securing
Sealing rings,
O-rings
elements, O-rings and oil seals.
Before re-assembly check components whether parts are missing. Only
Re-assembly
use adhesives, lubricants, cleaning agents and solvents indicated in the
maintenance instructions. If not respected, damage may be the conse-
quence.
1.4)

Trouble shooting

In the Operators Manual, possible problems are listed. At the same time, a
General notes
brief description of the necessary remedial action is given.
See chapter 12 in the Operators Manual for engine type 914 (Series).
Effectivity: 914 Series
Edition 2 / Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
In order to avoid mechanical damages, never loosen
NOTICE
WARNUNG
or tighten screws and nuts with pliers but only with the
specified tools.
If during disassembling/reassembling the removal of a
NOTICE
WARNUNG
safety item (e.g. safety wiring, self-locking fastener,
etc.) should be necessary, it must be always replaced
by a new one.
All metall and synthetic parts are generally washed
NOTICE
WARNUNG
with suitable cleaning agents. Before using new and
unknown cleaning agents check the compatibility of
materials.
Non-compliance can result in serious injuries or death!
WARNUNG WARNING
Exactly observe the tightening torques for screws and
nuts. Overtightening or too loose connection could
cause serious engine damage.
05-00-00
page 6
January 01/2010