Notes On A Multiple Lan Adapter Configuration; Cautions For Using Serverstart - Fujitsu Primergy BX620 S4 User Manual

Chapter 2 Checking before OS Installation

2.3.3 Notes on a Multiple LAN Adapter Configuration

Using the OS installation wizard of ServerStart, you can configure multiple LAN adapters (network
adapters) on the system. However, there are the following limitations.
●
Adapter numbers
To configure multiple LAN adapters (PG-2861L/PG-LND201, etc.), select the adapter numbers in order
of Adapter 1 and Adapter 2, and enter settings for each adapter. Note that the order of adapter numbers is
not necessarily the same as the onboard LAN port numbers. This means that the setting for Adapter 1 is
not always applied to LAN port 1 of the onboard LAN. After installing the OS, check the LAN adapters
to make sure that they are configured as intended.

2.3.4 Cautions for Using ServerStart

Observe the cautions described below when the OS installation is performed with ServerStart.
■ Operating ServerStart
Mainly, a mouse is used for ServerStart operations. In some cases, operation with the [Tab] key or cursor
are not available. Be sure to use a mouse while operating ServerStart.
■ Configuration file (SerStartBatch.ini)
A configuration file stores the server setup and client information configured in ServerStart. To create a
configuration file, use the ServerStart floppy disk. Store only one file on each floppy disk. Do not set the
ServerStart floppy disk to the write-protected state. You can use any name for the configuration file.
However, the file must be installed in the server as "SerStartBatch.ini". When installing the
configuration file, make sure to save it as "SerStartBatch.ini" on the ServerStart floppy disk. Start up
ServerStart, insert the ServerStart floppy disk containing "SerStartBatch.ini", and click [Start] to install
the server
■ Ejecting PRIMERGY Startup Disc
Do not eject PRIMERGY Startup Disc while ServerStart is running. If the PRIMERGY Startup Disc is
ejected and inserted again, ServerStart starts up in multiple windows, and settings you have made may
be lost.
■ Exiting ServerStart
After operation in the expert mode, exiting ServerStart restarts the system. Remove discs from the
floppy disk and CD/DVD drives and click [OK]. When the display on the screen disappears, turn off the
system.
40