Table of Contents
Advertisement
6
Calibration Procedures
Adjustments procedures
2 Press Shift >
3 Perform
4 Repeat
N O T E
210
+S + + –
– –S
EXT
to enable remote sensing. When the U3606A is
operating in remote sensing mode, the EXT annunciator on the front
panel is illuminated.
step 2
through
— front output terminals"
for the constant current output adjustment items.
step 3
through
front output terminals"
Voltage to select the S1 range (the S1 annunciator is illuminated).
For adjustment item "LOAd", connect a 30 Ω, 50 W load across the front
panel + rear output terminal and the I (red) terminal. Leave the
– rear terminal and LO (black) terminal connected.
Do not remove the short bar between the rear panel sense terminals (+S
and –S) are the rear panel output (+ and –) terminals. See
sensing connections"
connect the load leads.
step 7
of the
"CC output adjustment procedure
on page 205. Refer to
step 7
of the
"CC output adjustment procedure —
on page 205 for the S1 (30 V/1 A) range. Press
on page 100 for more information on how to
Table 6- 11
on page 206
"Remote
U3606A User's and Service Guide
Advertisement
Table of Contents
