Table 6-8 Ac Current Gain Adjustment - Agilent Technologies U3606A User's And Service Manual

6 Enter the actual applied input (see
7 Press
8 Repeat
9 Verify the AC current gain adjustments using the

Table 6-8 AC current gain adjustment

1.0000 mA, 1 kHz
10.0000 mA, 1 kHz
100.000 mA, 1 kHz
1000.00 mA, 1 kHz
Capacitance gain adjustment procedure
Review the
considerations"
1 Press
2 The primary display will show the uncalibrated value and the upper
3 Configure each adjustment item shown in
U3606A User's and Service Guide
page 184).
O U T
to start the adjustment. The display "CALib" in the lower
S BY
secondary display starts flashing to indicate that the calibration is in
progress.
• Successful completion of the adjustment is indicated by a short beep
and the primary display briefly showing "PASS".
• An adjustment failure is indicated by a long beep, the primary
display showing "FAiL" and a calibration error number appearing in
the upper secondary display. Correct the problem and repeat this
procedure.
step 3 through
Table 6- 8.
verification test"
Adjustment item
"Test Considerations"
on page 191 sections before beginning this procedure.
to enter the capacitance gain calibration.
secondary display will show the reference value of the adjustment item.
"Entering adjustment values"
step 7 for each gain adjustment point shown in
on page 154.
Input current
1 mA
10 mA
100 mA
1000 mA
on page 140 and
Calibration Procedures
Adjustments procedures
"AC current
Input frequency
1 kHz
1 kHz
1 kHz
1 kHz
"Gain adjustment
Table 6- 9.
6
on
201