Pulse Motor Speed Selection - TEC CB-416 Series Maintenance Manual

5. DIAG. TEST OPERATION

5.3.5.4 Pulse Motor Speed Selection

If a color misalignment occurs when using the ribbon saving function frequently, increase the pulse
motor speed by 4% to prevent the color misalignment.
NOTES: 1. Usually select "AUTO" for the pulse motor speed. A color misalignment may
2. Select "104" for the pulse motor speed if a misalignment occurs even after the
3. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds
4. A changed threshold fine adjustment value is stored in memory by pressing the
5. The default setting is Auto.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
< 1 > D I A G .
Press the [FEED] key.
< 2 > P A R A M E T E R
Press the [PAUSE] key.
P O S I T I O N
Press the [FEED] key four times.
P R I N T E R
Press [PAUSE] key four time.
P U L S E M O T O R
Press the [FEED] or [RESTART] key to
select the motor type.
Press the [FEED] key and
[RESTART] key at the
same time.
occur, however, according to the print patterns even when "AUTO" is selected.
In this case, fine adjust the platen speed in Section 5.3.6 Platen Speed Fine
Adjustment Mode. If the paper becomes slack between the platens with "AUTO"
pulse motor speed, increase the platen speed by pressing the [FEED] key.
platen speed fine adjustment, or the printer prints such print patterns that the all
print heads frequently up and down in ribbon saving mode.
enables a fast forward.
[PAUSE] key.
V 1 . O A
S E T
P A R A Printer parameter setting display
Pulse motor speed selection
AUTO : Automatically set
A U T O
104 : Increased by 4%
Press the [PAUSE] key.
Continued on section 5.3.5.5
Euro Font Code Selection.
5-36
EO18-33002A
(Revision Date: Dec. 20, 2000)
5.3 PARAMETER SETTING MODE