TEC CB-416 Series Maintenance Manual page 37

5. DIAG. TEST OPERATION
NOTES: 1. Item from (2) through (16) are initialized to "0" after RAM clear.
2. If the distance is 5.5 m or less, it is rounded down and no data is added to the
3. If the count is 31 counts or less, it is rounded down and no data is added to the
4. If the driving time is 36 sec. or less, it is rounded down and no data is added to the
5. When a sent command results in an error, the same number as the data capacity
2) Parameters
#
(9) FEED [KEY]
FEED [PC]
(10) CUT [PC, KEY]
(11) BACK [KEY]
BACK [PC]
(12) STOP [PC, KEY]
(13) X ADJ.
(14) X DIRECTION
(15) Y DIRECTION
(16) TONE
(17)
RIBBON
VOLTAGE
FONT
(18)
CODE
(19)
memory at power off.
memory at power off.
memory at power off.
of the command is counted by byte.
Item
Print start position fine adjustment
Print start position fine adjustment
Cut position fine adjustment
Reverse feed distance fine adjustment
Reverse feed distance fine adjustment
Print stop position fine adjustment
X-coordinate fine adjustment
X-direction fine adjustment
CB-416: Black/Magenta/Cyan/Yellow
CB-426: HEAD1/HEAD2
Y-direction fine adjustment
CB-416: Black/Magenta/Cyan/Yellow
CB-426: HEAD1/HEAD2
Print tone fine adjustment
CB-416: Black/Magenta/Cyan/Yellow
CB-426: HEAD1/HEAD2
REWIND
Ribbon take-up motor voltage fine adjustment
CB-416: Black/Magenta/Cyan/Yellow
CB-426: HEAD1/HEAD2
SUPPLY
Ribbon feed motor voltage fine adjustment
CB-416: Black/Magenta/Cyan/Yellow
CB-426: HEAD1/HEAD2
Character code selection
Font zero selection
Control code selection
Description
5-9
EO18-33002A
(Revision Date: Dec. 20, 2000)
5.2 SELF TEST MODE
Remarks
-30.0 mm ~ +13.0 mm
-30.0 mm ~ +10.0 mm
-20.0 mm ~ +20.0 mm
-9.5 mm ~ +9.5 mm
-9.9 ~ +9.9 mm
-30.0 ~ +300.0 mm
-99.5 mm ~ +99.5 mm
-2.00 mm ~ +2.00 mm
-2.00 mm ~ +2.00 mm
-50 ~ +50 step
-50 ~ +50 setp
-50 ~ +50 setp
PC-850 : PC-850
PC-8: PC-8
0: No slash used.
0: Slash used.
AUTO:
Automatic selection
ESC LF NUL:
ESC LF NUL mode
{ | } : { | } mode