Y-Direction Fine Adjustment - TEC CB-416 Series Maintenance Manual

5. DIAG. TEST OPERATION

5.3.3.4 Y-Direction Fine Adjustment

Check the point where a line of each color aligns with a black line on theYX-direction test pattern
and enter the obtained adjustment value.
< 1
< 2
P O
H E
P R
Press the [FEED] key three times.
Y
•CB-416
B L
M A
M A
NOTES: 1
2. This operation allows the max. of ± 4.00 mm change for each color adjustment.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
> D I A G . V 1 . O A
Press the [FEED] key.
> P A R A M E T E R S E T
Press the [PAUSE] key.
S I T I O N
Press the [FEED] key twice.
A D A D J U S T
Press [PAUSE] key.
I N T C O N D I T I O N
D I R E C T I O N
Press [PAUSE] key.
A C K B 0 0
Press the [PAUSE] key twice.
G E N T A B 0 0
Set the alphabet with the
[FEED] or [RESTART] key.
Press the [PAUSE] key.
G E N T A B 0 0
Set the number with the
[FEED] or [RESTART] key.
(See NOTE 1.)
Press the [PAUSE] key.
Press the [FEED] key and
[RESTART] key at same time.
When setting C or D for alphabet, the range of the number becomes 01 to 29.
X and Y-directions fine adjustment
display
Print condition setting display
Y-direction fine adjustment display
Skip Black's Y-direction
H E A
fine adjustment
Press the [PAUSE] key.
Magenta's Y-direction
H E A
fine adjustment value
(Number)
Alphabet: A, B, C, or D
Set the alphabet with the
[FEED] or [RESRART] key.
H E A
Magenta's Y-direction
fine adjustment value
(Number)
Set the Number with the
[FEED] or [RESRART] key.
Number: 00 to 30
See NOTE1
CYAN
YELLOW
Repeat the above
procedure to other
print heads.
Press the [PAUSE] key.
5-27
5.3 PARAMETER SETTING MODE
•CB-426
D 1 B 0 0
D 2 B 0 0
D 2 B 0 0
Press the [PAUSE] key.
EO18-33002A
Skip 1st print head
Y-direction fine
adjustment
2nd print head
Y-direction fine
adjustment value
(Number)
Alphabet: A, B, C,
or D
2nd print head
Y-direction fine
adjustment value
(Number)
Number: 00 to 30