5. DIAG. TEST OPERATION
5.2 SELF TEST MODE
In self test mode the printer status is printed in two types of sample print.
5.2.1
Automatic Diagnostic Printing
The data from 1 to 9 on a sample print is printed.
< 1
S E
Select the sensor type from those
at the right by pressing the
[FEED] key or [RESTART] key.
A U
C H
NOTES:
1. If the automatic diagnosis printing results in an error, the printer will display the
2. Both label and tag paper can be used for printing.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
>
D I A G .
V 1 . O A
Press the [PAUSE] key.
N
S O R
T R A N S .
Press the [PAUSE] key.
Press the [FEED] key.
T
O
D I A G N O S T I C
Press the [PAUSE] key.
E
C K I N G
&
P R I N T
The result of the self test
is printed. After printing,
the initial display will be
shown.
error message and stop printing. The error status can be cleared by the [PAUSE]
key, however, the display will return to the initial display "<1> DIAG. V1.0A".
Printing is not automatically resumed.
Press the [PAUSE] key.
Continued on Section 5.2.2
Maintenance counter printing.
NONE
(consecutive form)
REFLECTIVE
(black mark sensor)
TRANSMISSIVE
(feed gap sensor)
The printer is checking or printing
the status
5-2
EO18-33002A
5.2 SELF TEST MODE