Ribbon Module (Cb-1004-Qm) - TEC CB-416 Series Maintenance Manual

3. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

3.2 RIBBON MODULE (CB-1004-QM)

Ribbon Module
Ribbon Tension Sheet
Sheet Fixing Plate
D-3x5 Screw
1) Remove the ribbon stopper from the ribbon shaft.
2) When the CB-1904-RK-QM Super Premium Ribbon Kit is installed in the printer, attach the enclosed
ribbon tension sheet and the sheet fixing plate using the following procedure.
NOTE: Do not attach the ribbon tension sheet to the ribbon module when the CB-1904-RK-QM is not
installed.
Remove the ribbon guide lever from the ribbon module.
Fit the bosses on the sheet fixing plate into the holes of the ribbon tension sheet and the aluminum
frame. Secure them with the three D-3x5 screws.
The double-sided adhesive tape does not need to be used.
NOTE: Do not reassemble the ribbon guide lever, ribbon guide lever shaft and D-3x6 screw because
they are unused after the ribbon tension guide sheet has been installed.
Ribbon Cassette
D-3x5
A
Ribbon Tension Sheet
Double-sided
Adhesive Tape
Description
Aluminum Frame
Boss
D-3x6
Sheet Fixing Plate
B
Q'ty/Unit
1
1
1
3
Ribbon Guide Lever
Ribbon Guide
Lever Shaft
A
3-3
3.2 RIBBON MODULE (CB-1004-QM)
Fig. 3.4
B
EO18-33002A
Fig. 3.5