Pre-Strip Selection; Back Feed Speed Selection - TEC SX4T - B B/W Direct Thermal User Manual

5. SYSTEM MODE

5.4.26 Pre-Strip Selection

With this parameter you can select whether or not the Pre Strip function is activated.
When "<2>PARAMETER SET" appears, press the [PAUSE] key and the [FEED] key 25 times.
Press the [PAUSE] key to start. Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting the Pre Strip, press the [PAUSE] key.
NOTE: When the print speed is set to 10"/sec., the pre-strip function will be activated regardless of
this parameter setting.

5.4.27 Back Feed Speed Selection

With this parameter you can select the speed of back feed. When "<2>PARAMETER SET"
appears, press the [PAUSE] key and the [FEED] key 26 times.
Press the [PAUSE] key to start. Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting the Back Feed Speed, press the [PAUSE] key.
Unavailable
Available
STD: 3 inch/second
LOW: 2 inch/second
5-32
EO18-33012A
5.4 PARAMETER SETTING