TEC CB-416 Series Maintenance Manual page 22

3. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
4) Attach the cutter cover to the cutter unit with the two screws.
Cutter Cover
5) Closet the top cover.
6) Remove the VR blind cover from the rear of the printer and set the DIP switch 2-2 to ON.
7) When the cut position needs to be fine adjusted, refer to section 5.3.1.2.
Adjust Cut Angle
When the cutter cuts media obliquely, follow the procedure below to adjust the cut angle.
1) Loosen the two SMW-4x8 screws.
2) Move the guide plate back or forth so that the cutter is perpendicular to the media. Tighten the same
SMW-4x8 screws.
SMW-4x8 Screw
3) Put the ribbon onto the ribbon shaft so that the notch of the ribbon core aligns with the protrusion on
the ribbon shaft.
Screw
Guide Plate
Cutter Unit
3-2
EO18-33002A
3.1 CUTTER MODULE (CB-1204-QM)
Fig. 3-2
SMW-4x8 Screw
Fig. 3-3