Ram Clear Mode - TEC CB-416 Series Maintenance Manual

5. DIAG. TEST OPERATION

5.5 RAM CLEAR MODE

In RAM clear mode, various data written on the EEP-ROM can be initialized. There are three clear
functions; Maintenance counter clear, parameter clear and print step clear in the parameter setting mode.
After referring to the following table specify and clear or initialize the data.
RAM Clear Mode Table
Mode Name
NO RAM CLEAR
MAINTE. CNT CLEAR
PRINT STEP CLEAR
If you enter the RAM clear mode by mistake, specify this mode to
eacape from the RAM clear mode without excuting RAM clear.
After replacing the print head, cutter module, ribbon feed/rewind motor,
solenoid and CPU PC Board, clear the maintanance counter.
The following data will be cleared to zero. Confirmation can be made
through the maintenance counter procedure in self test mode. (See
NOTE 1)
Total feed length
Print distance
Print distance
Print distance
Print distance
Cut count
Head up/down
Head up/down
Head up/down
Head up/down
Ribbon motor driving hours (CB-416:black, CB-426:1st)
Ribbon motor driving hours (CB-416:magenta, CB-426:2nd)
Ribbon motor driving hours
Ribbon motor driving hours
RS-232C hardware error count
Instantaneous power failure count
Print head run distance (CB-416:black, CB-426:1st)
Print head run distance (CB-416:magenta, CB-426:2nd)
Print head run distance
Print head run distance
5-51
Function
ITEM
(CB-416:black, CB-426:1st)
(CB-416:magenta, CB-426:2nd)
(CB-416:cyan)
(CB-416:yellow)
(CB-416:black, CB-426:1st)
(CB-416:magenta, CB-426:2nd)
(CB-416:cyan)
(CB-416:yellow)
(CB-416:cyan)
(CB-416:yellow)
ITEM
(CB-416:cyan)
(CB-416:yellow)
EO18-33002A
5.5 RAM CLEAR MODE
Initial value
0 Km
0 Km
0 Km
0 Km
0 Km
0 time
0 time
0 time
0 time
0 time
0 hours
0 hours
0 hours
0 hours
0 times
0 times
Initial value
0.0 Km
0.0 Km
0.0 Km
0.0 Km