5. DIAG. TEST OPERATION
Parameter Setting Mode Table
Mode Name
POSITION
PRINT DENSITY
HEAD ADJUST
HEAD ADJUST3
SUPPLY HOLDER
RESOLUTION
PRINTER PARA
PM ADJUST
HEAD SELECT
RIBBON
<Position adjustment mode>
Fine adjustment of the print start position, cut position, reverse feed
distance, print stop position, and X-coordinate
<Print tone fine adjustment mode>
Print tone fine adjustment of each print head
<X and Y-directions fine adjustment mode>
Fine adjustment of each color's alignment
• PRINT CONDITION: print condition setting
• ADJUST: Status print before X/Y-directions adjustment
• X DIRECTION: X-direction alignment fine adjustment
• Y DIRECTION: Y-direction alignment fine adjustment
• CHECK: Adjustment value confirmation print
<Print start position fine adjustment mode>
Print start position fine adjustment of each print head for page 1 to page
10
<Supply holder's paper end sensor selection>
Selection of the use of the supply holder's paper end sensor
<Resolution selection>
Selection of the resolution
<Printer parameter setting mode>
Selection of the character code, font zero, control code, Euro Code
and pulse motor speed
<Platen speed fine adjustment mode>
Fine adjustment of the platen speed
<Color designation mode>
Selection of used or unused print head
<Ribbon type selection>
Setting the ribbon type for each print head
5-11
5.3 PARAMETER SETTING MODE
Function
EO18-33002A
(Revision Date: Dec. 20, 2000)