Printer Parameter Setting Mode; Character Code Selection - TEC CB-416 Series Maintenance Manual

5. DIAG. TEST OPERATION
5.3.5

Printer Parameter Setting Mode

5.3.5.1 Character Code Selection

NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds
2. A changed font code is stored in memory by pressing the [PAUSE] key.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
< 1 > D I A G .
Press the [FEED] key.
< 2 > P A R A M E T E R
Press the [PAUSE] key.
P O S I T I O N
Press the [FEED] key four times.
P R I N T E R
Press the [PAUSE] key .
F O N T C O D E
Select either character code with
the [FEED] key or [RESTART]
key. (See NOTE 1.)
Press the [FEED] key
and [RESTART] key
at the same time.
enables a fast forward.
V 1 . O A
S E T
P A R A
P C - 8 5 0
Press the [PAUSE] key.
Continued on Section 5.3.5.2
Font zero selection.
5-33
(Revision Date: Dec. 20, 2000)
5.3 PARAMETER SETTING MODE
Printer parameter setting display
Character code selection
PC-850
PC-8
EO18-33002A