5. DIAG. TEST OPERATION
5.3.4
Print Start Position Fine Adjustment Mode
Using the following procedure, the print start position of each print head can be fine adjusted for
page 1 to page 10.
NOTES:
1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds
2. A changed font code is stored in memory by pressing the [PAUSE] key.
3. Adjustment in positive (+) direction makes the print start position moves toward the
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
< 1
>
D I A G .
Press the [FEED] key.
< 2
>
P A R A M E T E R
Press the [FEED] key.
P O
S
I T I O N
Press the [FEED] three times.
H E
A
D
A D J U S T 3
Press the [PAUSE] key .
B L
A
C K
Select the print head type with the
[FEED] key or [RESTART] key.
Press the [PAUSE] key .
P A
G
E 1
Select the print start position fine
adjustment value with the [FEED] key
or [RESTART] key.
Each time the [PAUSE] key is pressed,
the display will change to the fine adjustment
screen for the next page (page 2 to page 10).
Press the [PAUSE] key .
enables a fast forward.
feed direction. Negative (-) direction adjustment makes the print start position
moves toward the back feed direction.
V 1 . O A
S E T
Print start position adjustment display
Print head selection
+ 0 . 2 0 m m
5-32
(Revision Date: Dec. 20, 2000)
5.3 PARAMETER SETTING MODE
Black
Magenta
Cyan
Yellow
[FEED] key
Pressing the [FEED] key one time
is a -0.01 mm change, up to -1.00 mm.
[RESTART] key
Pressing the [PAUSE] key one time is
a +0.01 mm changed, up to +1.00 mm.
EO18-33002A