5. DIAG. TEST OPERATION
Adjustment example (CB-426)
X-direction fine adjustment method is explained using 2nd print head.
2
2nd Print
Head
3
2nd Print
Head
1) Check where 2nd print head belongs among rows E~H within the portion 1.
2) In this example, 2nd print head is printed on the row F. When 2nd print head is printed on the row
E or F, refer to the upper print sample.
When row G or H, refer to the lower print sample.
3) Check where a 2nd print head aligns with the black line (indicated by 2). Read the scale of the
position (indicated by 3).
4) Enter the alpha-numerics obtained in steps 1) through 3) into the Head Adjust display. In this case,
enter F1.
1
5-26
EO18-33002A
5.3 PARAMETER SETTING MODE
These lines indicate Y-
direction alignment.
(When they align and form
an almost straight line, the
adjustment is completed.)
Feed
Magenta
X-direction misalignment
E and F : + (plus) direction
G and H : - (minus) direction