Adjustment Value Confirmation Print - TEC CB-416 Series Maintenance Manual

5. DIAG. TEST OPERATION

5.3.3.5 Adjustment Value Confirmation Print

The test patterns which shows the status after X/Y-directions adjustment are printed.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
< 1 > D I A G .
Press the [FEED] key.
< 2 > P A R A M E T E R
Press the [PAUSE] key.
P O S I T I O N
Press the [PAUSE] key twice.
H E A D A D J U S T
Press the [PAUSE] key.
P R I N T C O N D I T I O N
Press the [FEED] key four times.
C H E C K
Designated number of labels
are issued according to the
print conditions set in Section
5.3.3.1 by pressing the [PAUSE] key.
V 1 . O A
S E T
X and Y-directions fine adjustment display
Print condition setting display
5-30
EO18-33002A
5.3 PARAMETER SETTING MODE