Cut Position Fine Adjustment - TEC CB-416 Series Maintenance Manual

5. DIAG. TEST OPERATION

5.3.1.2 Cut Position Fine Adjustment

< 1
< 2
P O
C U
NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds
2. Max. fine adjustment ± 20.0 mm = Key fine adjustment value + PC fine adjustment
3. A changed cut/strip position value is stored in memory by pressing the [PAUSE]
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
> D I A G .
Press the [FEED] key.
> P A R A M E T E R
Press the [PAUSE] key.
S I T I O N
Press the [PAUSE] key twice.
T A D J . + 0 . 0 m m
Press the [FEED] or
[RESTART] key to adjust
the feed length.
(See NOTE 1.)
Press the [FEED] key
and [RESTART] key
at the same time.
enables a fast forward.
value.
When the value reaches the maximum, the value remains unchanged even if a
subsequent fine adjustment is performed.
key.
V 1 . O A
S E T
Position adjustment mode display
Cut position fine adjustment
[FEED] key:
[RESTART] key: pressing the [RESTART] key
Press the [PAUSE] key.
Continued on Section 5.3.1.3
Reverse Feed Distance Fine Adjustment.
5-13
5.3 PARAMETER SETTING MODE
pressing the [FEED] key one
time is a -0.5 mm change, up to
-20.0 mm. (See NOTE 2.)
one time is a +0.5 mm change,
up to +20.0 mm.
(See NOTE 2.)
EO18-33002A