5. DIAG. TEST OPERATION
5.2.2
Maintenance Counter Printing
The data from 1 to I on a sample print is printed. This data is the printer status and the
value set in the parameter setting mode.
NOTES:
1. If the maintenance counter printing results in an error, the printer will display the
2. Both label and tag paper can be used for printing.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
< 1
>
D I A G .
Press the [PAUSE] key.
S E
N
S O R
Select the sensor type from those
at the right by pressing the
[FEED] key or [RESTART] key.
Press the [PAUSE] key.
M A
I
N T E N A N C E
Press the [PAUSE] key.
C H
E
C K I N G
The result of the self test
is printed. After printing,
the initial display will be
shown.
error message and stop printing. The error status can be cleared by the [PAUSE]
key, however, the display will return to the initial display "<1> DIAG. V1.0A".
Printing is not automatically resumed after the error is cleared.
V 1 . O A
T R A N S .
NONE
(consecutive form)
REFLECTIVE
(black mark sensor)
TRANSMISSIVE
(feed gap sensor)
C O N T
&
P R I N T
5-7
5.2 SELF TEST MODE
The printer is checking or printing
the status
EO18-33002A