Print Tone Fine Adjustment - TEC B-672 Maintenance Manual

6. DIAG. TEST OPERATION
6.3.5
NOTES:
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es

Print Tone Fine Adjustment

Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
< 1 > D I A G N O S T I C
Press the [FEED] key.
< 2 > P A R A M E T E R
Press the [PAUSE] key five times.
T O N E A D J U S T
Press the [FEED] or
[RESTART] key to adjust
the feed length.
(See NOTE 1.)
Press the [PAUSE] key.
(See NOTE 3.)
T O N E A D J U S T
Press the [FEED] or
[RESTART] key to fine
adjust the print tone.
(See NOTE 1.)
Press the [FEED] key
and [RESTART] key
at the same time.
1 Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds
enables a fast forward.
2. A changed print tone value is stored in memory by pressing the [PAUSE] key.
3. Fine adjustment value equals to the sum of the values set by the PC command and
system mode (key operation) and each max. value is ± 10 step. However, the
upper limit of the adjustment value is decided according to the print speed to
protect the print head. If the set value exceeds the following upper limit, it is
automatically corrected to the proper value.
Upper Limit: 3"/sec.: +10 step, 4"/sec.: +5 step, 8"/sec.: +2 step.
V 1 . O A
S E T
< T > + 0
[FEED] key:
[RESTART] key: Pressing the [RESTART] key
< D > + 0
[FEED] key:
[RESTART] key: Pressing the [RESTART] key
Press the [PAUSE] key .
Continued on Section 6.3.6
Character code selection.
6-24
(Revision Date: Jan. 14 '99)
6.3 PARAMETER SETTING MODE
(Thermal transfer printing fine
adjustment)
Pressing the [FEED] key one
time is a -1 step change, up to -
10 steps. (See NOTE 2.)
one time is a +1 step change,
up to +10 steps. (See NOTE 2.)
(Thermal direct printing fine
adjustment)
Pressing the [FEED] key one
time is a -1 step change, up to
-10 steps. (See NOTE 2.)
one time is a +1 step change, up
to +10 steps. (See NOTE 2.)
EM18-33017