Cut/Strip Postion Fine Adjustment - TEC B-670 Series Maintenance Manual

6. DIAG. TEST OPERATION
6.3.2 Cut/Strip Position Fine Adjustment
< 1 > D I A G N O S T I C
< 2 > P A R A M E T E R
Press the [PAUSE] key twice.
C U T
NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds
2. Max. fine adjustment ± 50.0 mm = Key fine adjustment value ( ± 50.0 mm) + PC fine
3. A changed cut/strip position value is stored in memory by pressing the [PAUSE]
4. When using label with length of less than 38 mm, calculate the cut position fine
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [FEED] key.
A D J U S T
Press the [FEED] or
[RESTART] key to adjust
the feed length.
(See NOTE 1.)
Press the [FEED] key
and [RESTART] key
at the same time.
enables a fast forward.
adjustment value ( ± 50.0 mm)
When the value reaches the maximum, the value remains unchanged even if a
subsequent fine adjustment is performed.
key.
adjustment value using the expression provided on page 6-19.
V 1 . O A
S E T
+ 0 . 0 m m
[FEED] key:
[RESTART] key : Pressing the [RESTART] key one
Press the [PAUSE] key.
Continued on Section 6.3.3
Back feed length fine adjustment.
6-16
6.3 PARAMETER SETTING MODE
Pressing the [FEED] key one time
is a -0.5 mm change, up to -50.0
mm. (See NOTE 2.)
time is a +0.5 mm change, up to
+50.0 mm. (See NOTE2.)
EM18-33017