Reserve Tank - KYMCO People GT 200i Service Manual

Hide thumbs Also See for People GT 200i:
Table of Contents

Advertisement

3. INSPECTION/ADJUSTMENT
The spring will come out when the filter cap is
removed.
Let the engine oil drain out.
Check that the O-ring is in good condition.
Install a new oil filter.
Make sure the rubber seal on the oil filter
facing the left crankcase.

RESERVE TANK

COOLANT LEVEL INSPECTION
The reserve tank is under left floorboard. Check
the coolant level through the inspection window
at the left side skirt white the engine is at the
normal operating temperature, with the scooter
In an upright position.
If the coolant level is below the LOWER level
mark, remove the left floor mat, remove the lid
screw, the reserve tank lid, and then the reserve
tank cap to add coolant mixture until it reaches
the upper level mark.
Add coolant to the reserve tank only. Do
not attempt to add coolant by removing
the radiator cap. Coolant in the radiator
is under pressure and is very hot and
can cause serious burns.
3-5
People GT 200i
Spring
Reserve Tank

Advertisement

Table of Contents
loading

Table of Contents