KYMCO People GT 200i Service Manual page 123

12
. COOLING SYSTEM
WATER PUMP SHAFT REMOVAL
Disconnect the water hose from the right
crankcase cover.
Remove bolts attaching the right crankcase
cover.
Remove the water pump bearing snap ring
from the water pump assembly.
Remove the water pump shaft and inner
bearing.
Remove the water pump shaft outer
bearing.
WATER PUMP SHAFT INSTALLATION
Drive a new water pump shaft outer
bearing into the water pump assembly from
the inside.
Install the water pump shaft and shaft inner
bearing into the waster pump assembly.
Install the snap ring to secure the inner
bearing properly.
12-10
People GT 200i
Water Pump Shaft
Snap Ring
Water Pump Shaft
Mechanical Seal