KYMCO People GT 200i Service Manual page 151

13. FUEL INJECTION SYSTEM
People GT 200i
TPS INSPECTION
Support the scooter on a level surface.
Put the side stand up and engine stop switch
is at "RUN".
Turn the ignition switch to "ON".
Measure if the ECU voltage outputs to TPS
between the following terminals of the TPS
connector.
Terminal Normal
Violet/Red (+) – Green/Pink (-) 5 V
Throttle position sensor (TPS) resistance
(at 20°C/68°F) 3500~6500
TPS
Cable Ends
REMOVAL
Loosen the throttle cables with the adjusting
nuts.
Disconnect the throttle cable ends from
throttle seat.
Adjusting Nuts
ISC Sensor MAP Sensor
Disconnect the TPS, ISC and MAP sensor
connectors.
Loosen the air cleaner connecting hose band
screw.
Loosen the intake manifold band screw.
Remove the throttle body, MAP sensor, TPS
sensor and ISC sensor as a set.
TPS Sensor
13-24