Oil Tank Removal - KYMCO SUPER8 50 2T Service Manual

4
. LUBRICATION SYSTEM
OIL TANK

OIL TANK REMOVAL

Remove the met-in box. ( 12-5)
Remove the frame body cover. ( 12-5)
Remove the rear carrier. ( 12-5)
Remove the oil meter connector.
Remove the two bolts attaching the oil tank.
Disconnect the oil inlet line.
Drain the oil inside the oil tank into a clean
container.
Remove the oil tank.
The installation sequence is the reverse of
removal.
＊
• Connect the oil line properly.
• Bleed air from the oil pump after
installation.
• The oil tube clip (at the oil tank side)
must be locked from inside of the oil
tube joint.
Oil Meter
Wire Connector
SUPER8 50 2T
4-6